When using a DN series USB2.0/3.0 camera with software that runs on DirectShow, some camera property settings (flip V, flip H) may not be saved and may return to their original state the next time the software is started.
DN series USB2.0/3.0 cameras save most setting values on the camera body, but flip V and flip H are not saved on the camera body, but are saved on Windows for each account using the DirectShow system. ・Hold.
At this time, if the driver has been set up at least once with that account, property settings (flip V, flip H) that are not saved on the camera body will be saved in Windows, but if the driver is set up with another account, they will be saved. I know it won’t happen.
If you want to restore the status of Flip V, Flip H for a specific account the next time you start the software, you can do so by following the steps below.
1) If your account type is not administrator, change it to administrator.
You cannot set up the driver unless you are an administrator.
2) Delete the driver once.
3) Set up (reset up) the driver.
4) Restart your computer.
If the DN series USB2.0/3.0 camera is not found after restarting, restart again.
※ If you set up the driver again, the DirectShow module will also be set up again.
