It varies greatly depending on the frame rate of the USB camera.
If you use the viewer software that comes with our DN series, the actual measured frame rate will be displayed at the bottom.
(This is an actual value, not a theoretical value.)
In the example above, the actual frame rate is 41.94 frame/sec.
Approximately 90% of this value will be the maximum number of sheets that can be imported.
41.94×0.9=37.7. In this case, it is possible to save up to 37 images/sec.
However, two conditions are required:
・There is no count up in the bad frame (blue circle) above.
・The delay time below must be 0ms.
You can increase the number of images you can capture by increasing fps.
・Lower resolution
・Increase the clock speed (as long as bad frames do not occur)
・Change USB2 to USB3
External trigger voltage specifications
・Input voltage is 3.3V to 24V.
・Please set the input pulse width to 5.1μsec or more.
・The delay from inputting an external trigger to starting exposure is several μsec.
